| 1. Drill using a 1/8-inch wood bit
approximately 1 inch deep into the wall structure through the
pre-drilled holes in the track.
2. Align the guide rail over the holes and ensure the rail
is lever.
3. Fasten the rail to the wall through one of the middle
holes using the appropriate wood-screw.
4. Ensure that the rail is level, and install one of the
bottom fasteners.
5. Install the fasteners in the remaining pre-drilled
holes.
Repeat the drilling and fastening procedures through all of the
remaining, pre-drilled holes. Do not tighten the fasteners at the
top of the guide rails to leave enough room to install the shutter
box. |